Standard

NS-EN 10246-16:2000

Withdrawn
Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

This Part of EN 10246 specifies requirements for the ultrasonic testing of the area adjacent to the weld of welded steel tubes for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures NOTE: This inspection may alternatively, in accordance with EN 10246-15, be carried out on longitudinal edges of strip/plate (used in the manufacture of welded tubes) in the flat form prior to seam welding. Electric welded tubes may alternatively be inspected in accordance with EN 10246-14 assuming that the scanning coverage used is sufficient to detect the minimum imperfection length given in table 1. This Part of EN 10246 is applicable to the inspection of welded tubes with an outside diameter greater than 30 mm. No lower limit of wall thickness is specified but see note in 4.1. European Standard EN 10246 "Non-destructive testing of steel tubes" comprises the parts shown in Annex A.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 23.040.10
  • ICS 25.160.40
  • ICS 77.040.20
  • National Committee CEN/TC 459/SC 10

Legal references

EU law: 97/23/EC

Product Relations

Product life cycle