Standard

NS-EN 1115-1:1997

Withdrawn
Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

This Part of EN 1115 specifies the general aspects of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP) piping systems in the field of underground drainage and sewerage under pressure. In conjunction with Parts 2, 3, 5, 6 and 7 of EN 1115 it is applicable to GRP-UP piping systems with flexible, reduced-articulation or rigid joints primarily intended for use in buried installations. NOTE 1: Piping systems conforming to EN 1115 can also be used for above ground applications provided the influence of the environment and the supports is considered in the design of the pipes and joints. It is applicable to pipes and fittings, as well as their connection and the method of jointing to components of other plastics and non-plastics materials, when intended to be used for the conveyance of surface water or sewage under pressure, at temperatures up to 50 °C (subject to the limitations contained in clause 7). This standard is applicable to pipes and fittings of nominal sizes from DN 100 to DN 3000. This standard covers a range of nominal sizes, nominal stiffnesses and nominal pressures. NOTE 2: It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 23.040.01
  • ICS 23.040.20
  • National Committee SN/K 84

Legal references

EU law: 89/106/EEC

Product Relations

Product life cycle