Standard

NS-EN 10246-13:2000

Tilbaketrukket
Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This Part of EN 10246 specifies the requirements for the full peripheral ultrasonic testing of seamless and welded steel tubes, with the exception of submerged arc welded (SAW) tubes, for wall thickness measurement. The standard specifies acceptance levels and calibration procedures NOTE 1: Full peripheral testing does not necessarily mean that 100 % of the tube surface will be scanned. NOTE 2:This inspection may be carried out simultaneously with full peripheral ultrasonic testing for the detection of laminar imperfections (see EN 10246-14) using the same ultrasonic transducers for both inspection requirements. Under these circumstances, the percentage of the tube surface to be scanned is determined by the minimum lamination size to be detected as required by EN 10246-14. This Part of EN 10246 is applicable to the thickness measurement of tubes with a specified outside diameter equal to or greater than 25,4 mm and a minimum wall thickness of 2,6 mm. European Standard EN 10246 "Non-destructive testing of steel tubes" comprises the parts shown in Annex A.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • ICS 23.040.10
  • ICS 77.040.20
  • National Committee CEN/TC 459/SC 10

Referanser i lov

EU lov: 97/23/EC

Produktrelasjon

Produkt livssyklus