Standard

NS-EN ISO 8257-2:2006

Tilbaketrukket
Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

1.1 This part of ISO 8257 specifies procedures for moulding test specimens of PMMA materials in a specified state,and methods for measuring their properties. Any property listed in this part of ISO 8257 and referred to in combinationwith ISO 8257-1 shall be determined by the method referred to in this part of ISO 8257.1.2 No values are quoted for these properties. Those required for the designation of PMMA materials for mouldingand extrusion are given in ISO 8257-1. Other properties shall be determined by the appropriate methods referred toin this part of ISO 8257.1.3 The values determined in accordance with this part of ISO 8257 will not necessarily be identical to those obtainedusing specimens of different dimensions and/or prepared by different procedures. They may also be influencedby colorants and other additives. The values obtained for the properties of a moulding depend on the mouldingcompound, the shape of test specimen, the test method and the state of anisotropy. The last-mentioned depends onthe gating and the moulding conditions, for example temperature, pressure or injection rate. Any subsequent treatmentmust also be considered, for example conditioning or annealing.1.4 The thermal history and the internal stresses of the specimens may strongly influence thermal and mechanicalproperties and resistance to environmental stress cracking, but exert less effect on the electrical properties, whichmainly depend on the chemical composition of the moulding compound.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 2006-04
  • Versjon: 1
  • Varetype: NAT
  • ICS 83.080.20
  • National Committee SN/K 609

Produktrelasjon

Produkt livssyklus