Standard

NS-EN 14064-1:2010

Withdrawn

Note: This standard has a new edition: NS-EN 14064-1:2018

Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

This document specifies the requirements for blown loose-fill mineral wool products for in-situ installation in lofts, masonry cavity walls and frame constructions. Part 1 of this European standard is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling. This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards. NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed. This document does not cover factory made mineral wool (MW) insulation products or in-situ products intended to be used for the insulation of building equipment and industrial installations. Products with a declared thermal resistance lower than 0,25 m2?K/W or a declared thermal conductivity greater than 0,060 Wm/(m?K) at 10 °C are not covered by this document. This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 91.100.60
  • National Committee SN/K 30

Legal references

EU law: 305/2011, 89/106/EEC

Product Relations

Product life cycle