Standard

NS-EN 201:1997

Withdrawn

Note: This standard has a new edition: NS-EN 201:2009

Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

This standard specifies the essential safety requirements for injection moulding machines for the processing of plastics and/or rubber. All hazards listed in clause 4 are covered by this standard. The following machines are excluded: - machines on which the clamping unit can only be operated by the physical force of the operator; - machines for reaction injection moulding (RIM, see prEN 1612-1 and prEN 1612-2); - compression and transfer moulding machines (see EN 289); - direct on sole injection moulding machines and full boot injection moulding machines (Wellington type boots with textile inserts) (see prEN 1845). The safety requirements for the interaction between injection moulding machines and ancillary equipment are specified. The safety requirements for the ancillary equipment itself are not specified. This standard does not cover requirements for the design of an exhaust system. This standard applies to injection moulding machines manufactured after the date of issue of the standard.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 83.200
  • National Committee CEN/TC 145

Legal references

EU law: 89/392/EEC, 98/37/EC

Product Relations

Product life cycle