Standard

NS-EN 754-8:1998

Withdrawn

Note: This standard has a new edition: NS-EN 754-8:2016

Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

This part of EN 754 specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see figure 2), supplied in straight lengths. This standard only applies to tube produced by the porthole/bridge method of extrusion only (and then cold drawn to the final dimensions required). This standard only applies to cold drawn tube for general engineering applications made in the following alloys : EN AW-1050A, EN AW-1200, EN AW-1350 ; EN AW-3003, EN AW-3103 ; EN AW-5005, EN AW-5005A, EN AW-5051A, EN AW-5251, EN AW-5052 ; EN AW-6101A, EN AW-6101B, EN AW-6005, EN AW-6005A, EN AW-6012, EN AW-6018 ; EN AW-6351, EN AW-6060, EN AW-6061, EN AW-6261, EN AW-6262 ; EN AW-6063, EN AW-6063A, EN AW-6463, EN AW-6081, EN AW-6082 ; EN AW-7003, EN AW-7005, EN AW-7020. This standard does not apply to extruded cold drawn tube produced by the die/mandrel method or coiled tubes.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 77.150.10
  • National Committee SN/K 111

Product Relations

Product life cycle