Standard

NS-EN ISO 899-1:1996

Withdrawn

Note: This standard has a new edition: NS-EN ISO 899-1:2017

Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

1.1 This part of ISO 899 specifies a method for determining the tensile creep of plastics in the form of standard test specimens under specified conditions such as those of pretreatment, temperature and humidity. 1.2 The method is suitable for use with rigid and semi-rigid non-reinforced, filled and fibre-reinforced plastics materials (see ISO 472 for definitions) in the form of dumb-bell-shaped test specimens moulded directly or machined from sheets or moulded articles. 1.3 The method is intended to provide data for engineering-design and research and development purposes. 1.4 Tensile creep may vary significantly with differ-ences in specimen preparation and dimensions and in the test environment. The thermal history of the test specimen can also have profound effects on its creep behaviour (see annex A). Consequently, when precise comparative results are required, these factors must be carefully controlled. 1.5 If tensile-creep properties are to be used for engineering-design purposes, the plastics materials should be tested over a broad range of stresses, times and environmental conditions.

Document information

  • Standard from SN
  • Published:
  • Withdrawn:
  • Edition: 1
  • Version: 1
  • Document type: NAT
  • ICS 83.080
  • ICS 83.080.01
  • National Committee SN/K 609

Product Relations

Product life cycle