Standard

ISO 4759-3:2016

Historisk utkast

Merknad: Denne standarden har en ny utgave: ISO 4759-3:2016

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

ISO 4759-3:2016 specifies tolerances for flat washers of product grades A, C and F with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts. This part of ISO 4759 may be applied to non-flat washers however it does not include all the tolerances related to these washers. It applies to non-captive and captive washers, and to standard and non-standard washers. It does not apply to dynamic disc springs. Washers of product grades F and A are intended to be used with bolts, screws, studs and nuts of product grades A and B; washers of product grade C are intended to be used with bolts, screws, studs and nuts of product grade C. NOTE The product grade refers to a specific tolerance range related to dimensional and geometrical characteristics (product grade F for fine tolerances, product grade A for precise tolerances, product grade C for large tolerances). Annex A presents tolerances taken from ISO 286‑1 and ISO 286‑2.

Dokumentinformasjon

  • Standard fra ISO
  • Publisert:
  • products.specs.Expires:
  • Utgave: 4
  • Versjon: 1
  • Varetype: IS
  • ICS 21.060.30
  • ISO TC ISO/TC 2

Produktrelasjon

Produkt livssyklus