Standard

NS-EN 14064-1:2018

Publisert
Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This document specifies the requirements for blown and injected loose-fill mineral wool products for in situ installation in lofts, masonry cavity walls and frame constructions.This document is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling.This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed.This document does not cover factory made mineral wool (MW) insulation products or in situ products intended to be used for the insulation of building equipment and industrial installations.Products with a declared thermal resistance lower than 0,25 m2·K/W or a declared thermal conductivity greater than 0,060 W/(m·K) at 10 °C are not covered by this document.This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Utgave: 2018-10
  • Versjon: 1
  • Varetype: NAT
  • ICS 91.100.60
  • National Committee SN/K 30

Referanser i lov

EU lov: 305/2011

Produktrelasjon

Produkt livssyklus