Standard

NS-EN 14626:2012

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NS-EN 14626:2024

Forhåndsvisning

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This European Standard specifies a continuous measurement method for the determination of the concentration of carbon monoxide present in ambient air based on the non-dispersive infrared spectroscopic measuring principle. This standard describes the performance characteristics and sets the relevant minimum criteria required to select an appropriate non-dispersive infrared spectroscopic analyser by means of type approval tests. It also includes the evaluation of the suitability of an analyser for use in a specific fixed site so as to meet the data quality requirements as specified in Annex I of Directive 2008/50/EC [1] and requirements during sampling, calibration and quality assurance for use.The method is applicable to the determination of the mass con¬centration of carbon monoxide present in ambient air up to 100 mg/m3 carbon monoxide. This concentration range represents the certification range for CO for the type approval test.NOTE 1 Other ranges may be used depending on the levels present in ambient air. NOTE 2 When the standard is used for other purposes than for measurements required by Directive 2008/50/EC, the ranges and uncertainty requirements may not apply.The method covers the determination of ambient air concentrations of carbon monoxide in areas classified as rural, urban-background and traffic-orientated and those influenced by industrial sources. The results are expressed in mg/m3 (at 20 °C and 101,3 kPa).NOTE 3 100 mg/m3 of CO corresponds to 86 mol/mol of CO.This standard contains information for different groups of users.Clauses 5 to 7 and Annexes B, C and D contain general information about the principles of carbon monoxide measurement by non-dispersive infrared spectroscopic analyser and sampling equipment.Clause 8 and Annex E are specifically directed towards test houses and laboratories that perform type-approval testing of carbon monoxide analysers. These sections contain information about:- Type-approval test conditions, test procedures and test requirements;- Analyser performance requirements;- Evaluation of the type-approval test results;- Evaluation of the uncertainty of the measurement results of the carbon monoxide analyser based on the type-approval test results.Clauses 9 to 11 and Annex F are directed towards monitoring networks performing the practical measurements of carbon monoxide in ambient air. These sections contain information about:- Initial installation of the analyser in the monitoring network and acceptance testing;- Ongoing quality assurance/quality control;- Calculation and reporting of measurement results;- Evaluation of the uncertainty of measurement results under practical monitoring conditions.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 2012-08
  • Versjon: 1
  • Varetype: NAT
  • ICS 13.040.20
  • National Committee SN/K 136

Produktrelasjon

Produkt livssyklus